![]() Perform the ALL CLEAR OPERATION to clear the computer and set the speed scale:.This distance in centimeters is the most accurate number. In this method, properly inflate the tires, sit on the bike and measure the distance of one wheel length. Alternately, you can find the most accurate wheel calibration number by rolling the tire on the ground. Find the Wheel Calibration Number (Length of Tire Roll-Out)ĭetermine the length of the tire (Length in centimeters) from the Cross Reference Table.The following set up is required before use: NOTE: To utilize previously accumulated Odometer data, refer to the section "Manually Replacing Mileage into Odometer" described in the last section of this manual. The speed sensor, handlebar bracket and wheel magnet should be installed first. If not, re-adjust the position of the sensor and the magnet so that it meets the conditions and in the " Important" column. Spin the front wheel and see if the speed appears in the display. To re- move, slide it forward while pushing the lever. Slide the main unit until it clicks into position. Note: Allow enough wire clearance in the area marked with to insure you can turn the handlebars all the way from side to side without pulling the wire. Apply the bracket rubber pad to the bracket, so that the band fits the handlebar. Secure the wire along the fork with the nylon ties, and along the front brake cable with the spiral tube. Adjust the position of the sensor and the magnet so that it meets the conditions and in the "Important" column. The clearance between the sensor and the magnet should be less than 5 mm.Īttach the sensor temporarily, with the adhesive tape, to the inside of the right front fork.Īttach the magnet to the right side spoke of the front wheel.Align the magnet's center and the sensor's marking line while rotating the wheel.Paint thinner, benzine, alcohol or other chemicals may damage the surface.Īttach the sensor and the magnet properly so that their positions meet the following conditions and. To clean the computer, use mild soap and a soft cloth.Do not leave the main unit exposed to direct sunlight.Used batteries must be disposed of properly and in accordance with all local regulations.Be sure to securely mount the magnet, sensor and bracket on your bicycle, and periodically check to insure they are mounted securely.Do not concentrate too much on the computer operations while riding.Cateye Enduro 2 CC-ED200N - Cyclocomputer Manual Precautions
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |